I bought these for my FrSky D4R-II receivers. The tubes are quite short, they could do with another 3cm length. I just let the aerial wires hang out the top though. The adhesive pad is pretty strong, I used it in conjunction with tie-wraps though; there are holes back and front to put tie-wraps right through. I'd definitely buy more of these despite the short tubes. They're very compact and I prefer them to the usual 3D printed versions.

I bought these for my FrSky D4R-II receivers. The tubes are quite short, they could do with another 3cm length. I just let the aerial wires hang out the top though. The adhesive pad is pretty strong, I used it in conjunction with tie-wraps though; there are holes back and front to put tie-wraps right through. I'd definitely buy more of these despite the short tubes. They're very compact and I prefer them to the usual 3D printed versions.

I bought these for my FrSky D4R-II receivers. The tubes are quite short, they could do with another 3cm length. I just let the aerial wires hang out the top though. The adhesive pad is pretty strong, I used it in conjunction with tie-wraps though; there are holes back and front to put tie-wraps right through. I'd definitely buy more of these despite the short tubes. They're very compact and I prefer them to the usual 3D printed versions.

Buenas pajitas de antena no Nedd el titular como fuente tengo ese marco todavía por un precio barato se puede obtener dos pajitas de antena que encajan perfectamente en mi soporte impreso 3d en mi Drone fpv ya que son de tamaño estándar. No han volado con ellos todavía estoy seguro de que protegerán las antenas RX perfectamente bien.

Good antenna straws didn't Nedd the holder as I font have that frame yet for a cheap price you can get two antenna straws that fit perfectly in my 3d printed holder on my fpv Drone as they are standard size. haven't flown with them yet I'm sure they will protect the rx antennas perfectly well.

Buenas pajitas de antena no Nedd el titular como fuente tengo ese marco todavía por un precio barato se puede obtener dos pajitas de antena que encajan perfectamente en mi soporte impreso 3d en mi Drone fpv ya que son de tamaño estándar. No han volado con ellos todavía estoy seguro de que protegerán las antenas RX perfectamente bien.