Compatible naze 32 and other flight controller cleanflight /betaflight Top banggood !

Compatible naze 32 and other flight controller cleanflight /betaflight Top banggood !

Compatible naze 32 and other flight controller cleanflight /betaflight Top banggood !

Good size, good contrast. littlibe hot, easy settings.

Good size, good contrast. littlibe hot, easy settings.

Good size, good contrast. littlibe hot, easy settings.

Using this for a 3D print quad Snappy v2. Fits perfect.

Using this for a 3D print quad Snappy v2. Fits perfect.

Using this for a 3D print quad Snappy v2. Fits perfect.

The board that I received had one LED chip that was not fully soldered to the board so I had to use a heat gun to reseat the chip. After reseating the chip, the board functioned correctly. The compact size is perfect for my DIY micro drone as an indicator light for flight modes and orientation. A drawback is that mounting the board can be a bit difficult if using an M3 screw. One must use a plastic screw because a metal screw head will not fit between the LED chips and could damage them if over tightened.

The board that I received had one LED chip that was not fully soldered to the board so I had to use a heat gun to reseat the chip. After reseating the chip, the board functioned correctly. The compact size is perfect for my DIY micro drone as an indicator light for flight modes and orientation. A drawback is that mounting the board can be a bit difficult if using an M3 screw. One must use a plastic screw because a metal screw head will not fit between the LED chips and could damage them if over tightened.

The board that I received had one LED chip that was not fully soldered to the board so I had to use a heat gun to reseat the chip. After reseating the chip, the board functioned correctly. The compact size is perfect for my DIY micro drone as an indicator light for flight modes and orientation. A drawback is that mounting the board can be a bit difficult if using an M3 screw. One must use a plastic screw because a metal screw head will not fit between the LED chips and could damage them if over tightened.

I printed a little holder for this LED module. Easy to configure via Cleanflight. Recommended for every quad.

I printed a little holder for this LED module. Easy to configure via Cleanflight. Recommended for every quad.

I printed a little holder for this LED module. Easy to configure via Cleanflight. Recommended for every quad.

No recibido

modtaget ikke prøvet

No recibido

alles ok

alles ok

alles ok

Брал на самолеты для посадочных фар

Брал на самолеты для посадочных фар

Брал на самолеты для посадочных фар

perfect!

perfect!

perfect!

Quality looks good, shipping was 10 days to Australia. Haven't tested yet.

Quality looks good, shipping was 10 days to Australia. Haven't tested yet.

Quality looks good, shipping was 10 days to Australia. Haven't tested yet.