Comentarios de Clientes

4.68 fuera de 5
Escribe un Comentario
  • Todos los comentarios (281)
  • Imagen (35)
  • Video (2)
  • Todas Las Estrellas
    • Todas Las Estrellas(281)
    • 5 Estrellas(236)
    • 4 Estrellas(21)
    • 3 Estrellas(11)
    • 2 Estrellas(5)
    • 1 Estrellas(8)
Ordenar por:
Comentarios Recomendados
  • Comentarios Recomendados
  • Muy útil
  • Más Reciente
Reseñas solo de tu país (Honduras)
  • March-04 2017 16:07:56

    Needs patience to assemble, especially all the LEDs with 6 pins on each, found it best to test as I go to make sure that all three parts of each LED lit up and fix any bad joints. Came with all the right parts and included spares of surface mount parts, good if you lose one in the carpet. Good effect with the white covering to hide the LEDs and the acrylic matrix to make sharp square edges. Case fit together well and leaves access for fitting and replacing backup battery (not included). Quite a few

    Comentarios (1)
  • March-09 2017 16:33:18

    A little bit tricky to build but it is worth it :-) Somewhat difficult to solder the clock chip for instance, through the white protective layer you can't recognize a connected copper or ground area at once (DS3231 Pin 5-12 and 13). The buzzer alarm sound is frightful, so i better will not to use this function. Throughout the day my clock produces sporadic short buzzer-beeps (like touching the touch buttons) - a question to the developer… (Photos taken with protective film remaining on dev

  • June-17 2017 06:49:11

    The object is perfectly in line with description. Nice look, big display, good clock stability, all pieces present (plus some extras, very good), easy to mount (if you are familiar with SDM soldering), nice functions. Three points to improve: 1) the touch is a bit imprecise. Some times one touch is interpreted as multitouch and in a similar way set the time or surfing into the menu is sometimes not easy. 2) Temperature seem to me a bit higher than the true. It may depend of box that keep the Sensor

  • April-22 2017 12:44:48

    A well thought out little kit, easy to assemble using the instructions provided in the link. Apart from the ICs all of the surface mount components have spares which is really nice! I had a few spare LED's, a spare resistor of each value and even a spare little transistor / mosfet! May grab a few more later as gifts :)

  • April-20 2017 14:52:56

    Неплохие часы, но плохая реализация: отсутствует схема, некачественные светодиоды, близко расположены цифры при мигании двоеточия все сливается, длинные болты, нет автоподстройки яркости, мини юсб, в моем экземпляре постоянно пищит, пришлось выпаять buzzer.

  • April-02 2017 13:53:13

    Как увидел эти плоские часы, так сразу их захотел собрать. И не прогадал. Крупные и яркие, то что доктор прописал:) Из минусов отмечу, что нет автоматической регулировки яркости и не хватает по ширине двух рядов, а то секунды ":" прилипают к цифрам. Но видать это сделано специально,

  • January-05 2018 04:39:24

    Układ zegara w estetycznej obudowie, na mikrokontrolerze i układzie DS3231. Do przylutowania jest 105 diod led, wszystkie elementy to smd (montaż powierzchniowy), ale przy odrobinie staranności nie sprawia to problemu. Układ wyświetla czas, datę, temperaturę, dzień tygodnia i komunikaty na święta i nowy rok. Pracuje u mnie bez zastrzeżeń od 2 miesięcy. Polecam

  • February-12 2017 09:43:51

    after I fix the problem with the wrong chip, I really like the clock, the dispaly is quite big and the animation very smooth.

    Comentarios (2)
  • August-16 2019 02:39:19

    Grande projeto e ótima diversão o relógio e extremamente funcional e útil depois de montado fica muito bonito e diferenciado, porém tem que se atentar na soldagem dos leds é necessário experiência em componentes SMD.

  • ehntoo
    June-15 2017 22:01:51

    This is a great kit for learning SMD soldering. There sure are a lot of LEDs. ;) I also got some diagnostic practice locating a single bad LED that was already soldered and causing the display to malfunction. No worries, though, since there were 5 extra LEDs included. Other small SMD components you might lose easily (and I did) also include spares.


    Total 0 pages

    Go to page


    Puedes estar interesado

    recommendation for you
    • US$13.99
    • US$11.99
    • US$9.99
    • US$20.99
    • US$8.99
    • US$89.99
    • US$7.99
    • US$10.99
    • US$2.99
    • US$11.99
    • US$22.98
    • US$5.99
    • US$5.12
    • US$4.99
    • US$5.99
    • US$14.19
    • US$24.61
    • US$20.99