Comentarios de Clientes

4.95 fuera de 5
Escribe un Comentario
  • Todos los comentarios (431)
  • Imagen (36)
  • Video (0)
  • Todas Las Estrellas
    • Todas Las Estrellas(431)
    • 5 Estrellas(418)
    • 4 Estrellas(9)
    • 3 Estrellas(1)
    • 2 Estrellas(0)
    • 1 Estrellas(3)
Ordenar por:
Comentarios Recomendados
  • Comentarios Recomendados
  • Muy útil
  • Más Reciente
Reseñas solo de tu país (Honduras)
  • June-09 2020 10:08:16

    The sensor arrived well wrapped, the delivery was relatively agile (about a month). I managed to use 2 of the 6. So far everything is fine, I'm satisfied.

    Comentarios
  • March-02 2020 05:54:59

    Very fast shipping. Everything is good. Thanks!

    Comentarios
  • May-21 2020 10:01:25

    it arrived in half of estimated time and very well packed. I didn’t have time to test yet, but so far so good. good price, fast and safe delivered.

    Comentarios
  • August-04 2020 07:07:01

    Good for diy, pool temperature monitor.

    Comentarios
  • May-13 2020 04:26:42

    Works perfect, used to create sensor for the fridge

    Comentarios
  • April-20 2020 17:53:54

    easy to use in arduino IDE with all the data and libs on the internet.

    Comentarios
  • February-19 2018 06:05:36

    La sonda funziona perfettamente per la misura della temperature del mio acquario con arduino. Sensore digitale con risoluzione programmabile da 9 a 12 bit. (la lettura in 12bit richiede circa 600ms). Interfaccia 1wire che consente la comunicazione attraverso 1 solo pin di arduino. (Ffilo giallo DATA) Rivestimento della sonda flessibile e resistente. Consiglio l'acquisto per i vostri progetti.

    Comentarios
  • December-02 2017 16:42:05

    I've bought two of these probes to check the temperature in the room where computers are. They're connected to a Raspberry PI B+ (GPIO4 + 4K7 Ohm resistor) and it works fine. They're not very accurate (0,4° C between the 2 probes) but it's enough to get an idea of the temperature.

    Comentarios
  • May-14 2019 11:23:28

    works well. Think to use one_wire scanner (like this https://www.carnetdumaker.net/articles/faire-un-scanneur-de-bus-1-wire-avec-une-carte-arduino/) to obtain the address of the temperature sensor (sensor will be easer to use)

    Comentarios
  • March-05 2019 14:51:14

    Temperatursensor DS18B20 funktioniert am ESP8266 perfekt

    Comentarios
Show:

    Total 0 pages

    Go to page

    Go

    Puedes estar interesado

    recommendation for you
    • US$10.99
    • US$1.99
    • US$2.19
    • US$5.19
    • US$6.57
    • US$6.99
    • US$6.29
    • US$4.99
    • US$2.69
    • US$4.29
    • US$3.99
    • US$3.99
    • US$2.99
    • US$8.89
    • US$6.29
    • US$5.14
    • US$3.99
    • US$10.68