Comentarios de Clientes

4.9 fuera de 5
Ver todos 139 comentarios
Escribe un Comentario
  • Todos los comentarios (139)
  • Imagen (10)
  • Video (0)
  • Todas Las Estrellas
    • Todas Las Estrellas(139)
    • 5 Estrellas(130)
    • 4 Estrellas(7)
    • 3 Estrellas(0)
    • 2 Estrellas(1)
    • 1 Estrellas(1)
Ordenar por:
Comentarios Recomendados
  • Comentarios Recomendados
  • Muy útil
  • Más Reciente
Reseñas solo de tu país (Spain)
|
Mostrar original

Una parte de la reseña se ha traducido automáticamente.

  • 21/12/2014

    but nothing too bad. what is marked with (-) should go to pwm pin as signal, middle pin should go to ground from external power source (MB102 is great for that!) and what is marked as (S) becomes + from external 5v power. once this is connected laser is nice and precise.

    Comentarios (1)
    Mostrar original
  • 04/01/2017

    It's a great module but the laser itself is not really aligned with the board . It goes a little bit on the right ! That's the right way to connect it to your arduino : "S" : signal _connected to a digital pin "-" : Connected to the ground Middle pin : connected to 5 volt

    Comentarios
    Mostrar original
  • 02/06/2020

    bueno, pero gnd y 5v se mezclan

    Comentarios
    Mostrar original
  • 30/04/2019

    good quality It will be tested soon

    Comentarios
    Mostrar original
  • 20/01/2019

    Very small and cheap module for arduino.

    Comentarios
    Mostrar original
  • 15/04/2017

    This is very good priced item. I suggest buying it. Delivered fast and very useful.

    Comentarios
    Mostrar original
  • 01/05/2020

    estos funcionan muy bien y el sabor increíble

    Comentarios
    Mostrar original
  • 23/02/2020

    Gran pequeño módulo, aunque la zona de marcas fuera. Gnd obtiene 5v S a Suministro 0v para un permanente en estado. El mecanismo de enfoque funciona bastante bien para una viga ancha si es necesario.

    Comentarios (2)
    Mostrar original
  • 20/01/2018

    On Arduino UNO you can plug directly into GND 13 (put the middle pin in there) and use Pin 12 for the S pin.

    Comentarios
    Mostrar original
  • 19/09/2016

    Now all I need is the sharks on which to put this laser beam.

    Comentarios
    Mostrar original
Show:

    Total 0 paginas

    Ir a la pagina

    Puedes estar interesado

    recommendation for you
    • US$3.99
    • US$8.74
    • US$8.99
    • US$17.24
    • US$7.27
    • US$11.49
    • US$17.24
    • US$4.59
    • US$5.24
    • US$16.09
    • US$6.99
    • US$3.99
    • US$4.49
    • US$11.54
    • US$3.99
    • US$5.66
    • US$4.99
    • US$19.62