Comentarios de Clientes

4.95 fuera de 5
Ver todos 76 comentarios
Escribe un Comentario
  • Todos los comentarios (76)
  • Imagen (4)
  • Video (0)
  • Todas Las Estrellas
    • Todas Las Estrellas(76)
    • 5 Estrellas(72)
    • 4 Estrellas(4)
    • 3 Estrellas(0)
    • 2 Estrellas(0)
    • 1 Estrellas(0)
Ordenar por:
Comentarios Recomendados
  • Comentarios Recomendados
  • Muy útil
  • Más Reciente
Reseñas solo de tu país (Spain)
|
Mostrar original

Una parte de la reseña se ha traducido automáticamente.

  • 21/11/2016

    Despite the small difference in appearance, the device is as as described. Everything works normally. Only problem I had when supplied with 12.14 volts. Although LEDs lit, no output voltage. I suppose that the maximum supply voltage is a little less than 12 volts.

    Comentarios
    Mostrar original
  • 26/04/2018

    Used for Arduino projects - just search for "Arduino L9110S" on Google, and you will find Lib and examples. Even with a "short" on the motor side, I have not been able to "Kill" the board

    Comentarios
    Mostrar original
  • 26/05/2020

    El paquete DEBE ser mejorado. Algunos pines son plis

    Comentarios
    Mostrar original
  • 05/05/2018

    Pretty nice

    Comentarios
    Mostrar original
  • 17/03/2022

    Bonito y pequeño tablero. Todo bien para mi robot de bricolaje OTTO!

    Comentarios
    Mostrar original
  • 25/02/2022

    Todo bueno

    Comentarios
    Mostrar original
  • 07/09/2021

    Bien

    Comentarios
    Mostrar original
  • 14/07/2021

    Recibido en buen orden

    Comentarios
    Mostrar original
  • 26/03/2017

    Tested with a pro mini and worked great. I had to try two different power plug supply's, one was 12.3 volts even though it was labeled as 12 volts and it did not work. It did not damage it but be careful it might. 12 volts might be its absolute max. I will probably use this with a 9 volts just to be safe

    Comentarios
    Mostrar original
  • 07/03/2017

    Just be sure that you check the connections to match them with your circuit. (Vcc, GND, A1A, A1B,etc.) The connecting pins are in a different order than the ones on the controller shown in the diagrams in my project. Not a problem; the controller will work fine when you connect the wires correctly according to the labels printed on the board.

    Comentarios
    Mostrar original
Show:

    Total 0 paginas

    Ir a la pagina

    recommendation for you
    • US$12.64
    • US$25.40
    • US$17.31
    • US$6.99
    • US$12.69
    • US$6.93
    • US$22.99
    • US$10.38
    • US$28.86
    • US$3.44
    • US$17.99
    • US$6.99
    • US$13.99
    • US$4.59
    • US$15.64
    • US$8.39
    • US$8.99
    • US$18.47