Módulo de refuerzo de potencia DC-AC de doble canal de 12V a 220V 35W Módulo regulador de potencia
Una parte de la reseña se ha traducido automáticamente.
This small inverter works very well. However transistors need to be heatsinked if you want them to last and make this unit usable. You can take them out, put both of them on a big heatsink, and then connect their pins back to the board. You can increase the base resistors (1K) to 3.3K to draw less current (about 1A) at 12.7V DC input, and drive nicely a 220VAC 8-10W LED bulb of 740-1000LM, from points A & 2, with good efficiency. If you do not increase the resistors, you can drive bigger loads 30-50W but current and heat dissipation will increase. AC output is from points A & 2. DC output is from points B(+) and D(-). It is advised to connect an 680K resistor and a bypass capacitor 1.1-3.3uF/400V both in parallel to points B & D to smooth out the DC voltage and limit the peaks. Avoid to measure output voltages with a cheap multimeter as you may destroy it. Oscillation frequency is around 4.7-4.8KHz and the waveform produced is as shown in the pictures. I have also drawn its diagram.
Buen circuito soldaduras de buena calidad normal Turquía tramo de impuestos sólo paga en la entrega de 17 Tl
Llegó en 15 días en el intermedio, muy bueno por ese precio. Por la noche sólo 9-10 W LED es muy bueno para la bombilla o la carga de teléfono, se puede utilizar para la iluminación y la carga de alambre en el campamento.
Muy bien, muy bien. Llegó en la fecha que me dijeron
nice product, good for led bulbs
Gyors és pontos szállítás! Maximálisan meg vagyok elégedve a termékkel!
productos exactamente lo que quería