Módulo Transmisor de Láser KY-008 AVR PIC
Una parte de la reseña se ha traducido automáticamente.
but nothing too bad. what is marked with (-) should go to pwm pin as signal, middle pin should go to ground from external power source (MB102 is great for that!) and what is marked as (S) becomes + from external 5v power. once this is connected laser is nice and precise.
It's a great module but the laser itself is not really aligned with the board . It goes a little bit on the right ! That's the right way to connect it to your arduino : "S" : signal _connected to a digital pin "-" : Connected to the ground Middle pin : connected to 5 volt
bueno, pero gnd y 5v se mezclan
good quality It will be tested soon
Very small and cheap module for arduino.
This is very good priced item. I suggest buying it. Delivered fast and very useful.
estos funcionan muy bien y el sabor increíble
Gran pequeño módulo, aunque la zona de marcas fuera. Gnd obtiene 5v S a Suministro 0v para un permanente en estado. El mecanismo de enfoque funciona bastante bien para una viga ancha si es necesario.
On Arduino UNO you can plug directly into GND 13 (put the middle pin in there) and use Pin 12 for the S pin.
Now all I need is the sharks on which to put this laser beam.