Comentarios de Clientes

4.93 fuera de 5
Escribe un Comentario
  • Todos los comentarios (84)
  • Imagen (2)
  • Video (1)
  • Todas Las Estrellas
    • Todas Las Estrellas(84)
    • 5 Estrellas(78)
    • 4 Estrellas(6)
    • 3 Estrellas(0)
    • 2 Estrellas(0)
    • 1 Estrellas(0)
Ordenar por:
Comentarios Recomendados
  • Comentarios Recomendados
  • Muy útil
  • Más Reciente
Reseñas solo de tu país (Honduras)
  • April-24 2018 05:29:37

    For higher temperatures I will definitely use higher quality probe, but it will use a purpose for now I guess.

    Comentarios
  • June-23 2016 08:28:05

    I tested on my soldering iron and on room temperature. On soldering iron it is about 5°C off, but I am not sure whether soldering iron is accurate too. On room temperature, it is off by 2°C or less. Thanks.

    Comentarios
  • July-21 2020 08:43:02

    All good. Banggood !

    Comentarios
  • July-06 2020 10:10:09

    Arrivato funzionante :)

    Comentarios
  • June-17 2020 06:16:00

    quality product

    Comentarios
  • January-30 2016 11:25:51

    I have received 3 sensors, and set them up to compare to my Lab reference PT100. Found differences in resistance about 2.4 Ohms. And this translates to about 8 deg. of C - shift to the lower temperature. If using this sensor "as is" measured temperature of 21 deg. of C will be seen as 13 deg of C. (This problem also was reported by: tioted in 2015-07-29) To correct the problem, I have connected 2.4 Ohm 1% Metal Film resistor in series with the sensor. This corrected the problem but introduced some

    Comentarios
  • March-27 2015 10:21:48

    After I calibrate & linearize the critical band of temperatures, I use this sensors and runs fine. After 12 days of running the results were good for variation & accuracy,

    Comentarios (1)
  • October-24 2015 15:04:29

    Sonde con rapporto qualita' prezzo molto buono , precisione non eccellente, costruzione e ingombro buona...con tutti i limite delle pt100 a due fili.

    Comentarios
  • June-21 2019 07:28:27

    Reliable and well insulated temperature sensor. with its relatively small diameter fit even 2 sensors in a normal dip tube. So you can evaluate and process the same measurement at two different locations.

    Comentarios
  • July-10 2016 02:40:49

    Well produced PT100 temperature sensors. A ADC is needed to get readings on the computer but there are many solutions to be found. A small Arduino board or a DS2450 ADC for a 1-wire set up will do the trick.

    Comentarios
Show:

    Total 0 pages

    Go to page

    Go

    Puedes estar interesado

    recommendation for you
    • US$21.99
    • US$184.99
    • US$12.99
    • US$36.33
    • US$31.99
    • US$21.99
    • US$80.36
    • US$21.41
    • US$30.99
    • US$18.99
    • US$11.99
    • US$14.99
    • US$10.99
    • US$6.99
    • US$37.99
    • US$32.99
    • US$52.99
    • US$18.19