I had high hopes about this one since I need a Futaba T14SG compatible RX for very light indoor models. The RX itself looks nice and arrived with no damage. I tested it with a single servo connected to CH1 and lab power supply. It binds OK and seems to operate almost down to 2.5 V. Servo also responds as it should but there are two issues: 1) The servo starts acting nervous when the voltage drops below 3.4 V. I'm using 1S lipo so this is a problem, although not perhaps a major one. 2) If I bring my finger close to the Renesas MCU, the RX stops sending any signals to servos although the indicator LED is still lit normally. It even does not recover until power is cut and reapplied. The latter behavior is an indication of either a contact problem or SW issue in the MCU. I'm going to order the other version with connectors for testing to see if it is more stable.

I had high hopes about this one since I need a Futaba T14SG compatible RX for very light indoor models. The RX itself looks nice and arrived with no damage. I tested it with a single servo connected to CH1 and lab power supply. It binds OK and seems to operate almost down to 2.5 V. Servo also responds as it should but there are two issues: 1) The servo starts acting nervous when the voltage drops below 3.4 V. I'm using 1S lipo so this is a problem, although not perhaps a major one. 2) If I bring my finger close to the Renesas MCU, the RX stops sending any signals to servos although the indicator LED is still lit normally. It even does not recover until power is cut and reapplied. The latter behavior is an indication of either a contact problem or SW issue in the MCU. I'm going to order the other version with connectors for testing to see if it is more stable.

I had high hopes about this one since I need a Futaba T14SG compatible RX for very light indoor models. The RX itself looks nice and arrived with no damage. I tested it with a single servo connected to CH1 and lab power supply. It binds OK and seems to operate almost down to 2.5 V. Servo also responds as it should but there are two issues: 1) The servo starts acting nervous when the voltage drops below 3.4 V. I'm using 1S lipo so this is a problem, although not perhaps a major one. 2) If I bring my finger close to the Renesas MCU, the RX stops sending any signals to servos although the indicator LED is still lit normally. It even does not recover until power is cut and reapplied. The latter behavior is an indication of either a contact problem or SW issue in the MCU. I'm going to order the other version with connectors for testing to see if it is more stable.

Replaced antenna with a better one from an old micro quad. Works great. Board is labeled very well for ppm sbus etc...

Replaced antenna with a better one from an old micro quad. Works great. Board is labeled very well for ppm sbus etc...

Replaced antenna with a better one from an old micro quad. Works great. Board is labeled very well for ppm sbus etc...

very small an i liked it

very small an i liked it

very small an i liked it

I use it as DIY wireless usb dongle for flight simulator.

I use it as DIY wireless usb dongle for flight simulator.

I use it as DIY wireless usb dongle for flight simulator.