Antoine
- mis contenidos
- Todos los mensajes
- Comentarios
- Comentarios
- respuestas
- Preguntas
respuestas
Q: Does this fit 8.5x20mm motors or 6x15mm motors
Preguntado por BG955347333 sobre 2021-08-20 22:09:43
Antoine YES it can run counter clockwise. You need an ESC to control it. Just program the ESC to make it run CCW.
Servicial (0)
Q: Does this card have an analog signal?
Preguntado por BG531418141 sobre 2021-04-20 15:58:19
Antoine Yes, it is analog video
Servicial (0)
Q: Hi, do these have a QC sticker and a barcode sticker on the sides of them?
Preguntado por treesap sobre 2021-01-31 18:07:00
Antoine Yes, they have both QC and barcode stickers.
Servicial (0)
Q: What is the nema/ip rating of the enclosure?
Preguntado por BG213252540 sobre 2021-01-24 08:04:50
Antoine There is no IP protection. There are wide openings to reach the plugs.
Servicial (1)
Antoine Have you tried to move it by hand when it is off ? do tou feel any hard point ? Try to do a reset. And look at the camera movements while reseting. It should do a full revolution to detect end points. Hope it helps. ;-)
Servicial (0)
Q: if I disconnect the input wire will it save its wifi connection or it will freak out?
Preguntado por orentwig sobre 2020-12-30 02:52:19
Antoine Yes, wifi setting will be saved. No pb with that.
Servicial (0)
Antoine Sorry but no issue like yours. Have you tried using only the new one ? Are they using the same firmware ?
Servicial (0)
Antoine it's for 8520 motors.
Servicial (0)