Todos los mensajes

scaledesign 2020-01-07 08:52:01
1
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten:

Q: is this a 2 speed gear box or a one speed and does it have a deceleration auto brake?

Preguntado por Benjamin Moss sobre 2020-09-26 11:21:59

scaledesign It's just a one piece transfer case for 4WD. Strong though.

2020-09-26 06:24:19 Servicial (0)
Enviar
respuestas (3)

scaledesign I use simple rechargeable double AA's for mine. You're looking for 6 volts so 5 cells will do fine. I don't recommend lipo's for noob's since they don't run the vehicles enough to merit the extra attention, work and danger in maintaining them. Those connectors can be purchased on line at Banggood or your local hobby store. Hope that helps.

2020-09-18 06:31:24 Servicial (0)
Enviar
respuestas (1)

Q: What is the motor limit for this ESC? Like how many turn motor(11t, 17t etc)

Preguntado por BG502949998 sobre 2020-07-23 11:24:09

scaledesign It will depend on the motor you use. Each should say what the peak draw is (current stalled). I have this escapement in one of my crawlers running a 5 pole 550. Well within it's capabilities. This unit says 30A, peak current: 320A. Use that as your guide. Good luck.

2020-07-23 01:48:07 Servicial (0)
Enviar
respuestas (2)

scaledesign I see 10 pics with some close-up detail.

2020-07-16 07:54:23 Servicial (0)
Enviar
respuestas (1)
scaledesign 2020-07-15 07:22:24
0
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten:

scaledesign OK, no intent to insult your experience but I assume you have plugged the three wire controller wire into channel 2 of the receiver with the white signal wire facing the centre of the receiver? There is also an on-off switch that allows the power from the battery to run through the esc and to the receiver. Ensure that your battery is FULLY charged. Ensure that the battery polarity is not reversed. If it is, you could fry the unit. Motor doesn't matter for now. You can change that later if you wish. Good luck.

2020-06-11 07:15:58 Servicial (0)
Enviar
respuestas (6)

Q: Can the lights be turned on and off via the remote ?

Preguntado por siracmelih sobre 2020-05-20 06:05:28

scaledesign Not that I know of. They will give you turn signals when you turn and brake lights when you stop but I don't believe that they will all turn off via the controller.

2020-05-20 06:17:48 Servicial (0)
Enviar
respuestas (3)

Q: Is there a kit I can buy with all the components it needs?

Preguntado por BG994765556 sobre 2020-05-12 12:16:49

scaledesign No. If you want everything, ready to run, you will get their radio, servos and esc and normally, you will want to change these out regardless. Therefore you end up buying the electronics twice. This kit needs those three things plus a battery and charger. Buy a Hobbywing 1080 esc, a 25 kg metal servo for steering and GT5 Flysky for the radio. You'll have good equipment to install at the most reasonable price. Good luck.

2020-05-12 07:07:04 Servicial (0)
Enviar
respuestas (1)

Q: How long are the axles in cm

Preguntado por danshannon631 sobre 2020-05-04 07:48:48

scaledesign About 11 cm.

2020-05-04 09:05:07 Servicial (0)
Enviar
respuestas (2)

scaledesign The small red connectors are called JST I believe. They are standard fair with WPL and JRC. On the escapement, one of them is male and the other is female. One of the two reds, the male goes to the motor and the female goes to the battery. If your C24 was a kit, it may not have come with leads. You're going to want to standardize your leads. I would suggest buying a small packet of the red JST's, male and female. 4 and 5 cell packs are the norm and you can attach your leads accordingly into any small charger. Good luck.

2020-04-23 12:25:49 Servicial (1)
Enviar
respuestas (2)

Q: what is the width

Preguntado por adamlambert sobre 2020-03-23 03:10:42

scaledesign Motor-transmission mount is 5 cm wide where the mounting holes are.

2020-03-23 07:43:05 Servicial (0)
Enviar
respuestas (2)

Q: Hi, does it fot for Fayee FY003?

Preguntado por mboldizzoni sobre 2020-03-09 05:43:02

scaledesign Sorry. Can't find a FY003 listed on the site. So I can't say but I'm pretty sure the Fayee specific metal driveshafts would fit. I've used those as well on my FY004a. Just do a search on site for Fayee parts.

2020-03-09 07:55:14 Servicial (1)
Enviar
respuestas (2)