Todos los mensajes

Q: What exact firmware version should be flashed in this board Betaflight?

Preguntado por tfuse sobre 2017-12-20 01:51:18

hersch710 firmware target in bataflight is omnibusf4sd

2018-01-19 05:20:23 Servicial (4)
Enviar
respuestas (10)

Kekuj Maybe you can use the "contact us " to contact the banggood customer service team to help you.

2018-05-29 10:45:10 Servicial (0)
Enviar
respuestas (1)

Q: What exact firmware version should be flashed in this board Betaflight?

Preguntado por tfuse sobre 2017-12-20 01:51:18

tfuse Your answer is a joke... I still do not know what FIRMWARE target to flash onto this board in Betaflight. Troll on

2017-12-30 09:37:46 Servicial (0)
Enviar
respuestas (10)

tfuse SOLVED! The cable is extremely loose and I did not have it seated in the plug all the way. I will most likely have to glue it into place. All is good!

2017-12-29 01:05:58 Servicial (0)
Enviar
respuestas (2)

tfuse you can wire 5v either where you've mentioned or via the plug terminal underneath the board near the SD card reader. this allows you to make a super clean build with an ESC that has a plug terminal as well.

2017-12-28 02:21:34 Servicial (0)
Enviar
respuestas (1)

prylmannen Did you get voltage shown in Betaflight with this board? I powered it thru 5v but can´t get any voltage info. You used the connector to get it working?

2018-04-05 02:02:03 Servicial (0)
Enviar
respuestas (2)

Q: How is it powered? Cannot see any lipo power pads? Any manual included?

Preguntado por Tyrivh sobre 2017-11-17 12:52:23

tfuse It's powered from a 5v input. The input is either on the bottom of the board (as oriented in the 1st photo) or powered on the underside board with the supplied cable. This board can be used for either 4in1 ESCs or 4 independent ESCs.

2017-11-26 09:27:05 Servicial (0)
Enviar
respuestas (1)