Todos los mensajes

TiemeKuyper 2020-10-14 03:32:25
0
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten:

TiemeKuyper 2020-10-14 03:30:14
0
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten:

TiemeKuyper 2020-10-14 03:28:19
0
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten:

TiemeKuyper 2020-09-07 05:03:16
0
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten:

TiemeKuyper No chinese voice but a 2 pitched sine-like sound when startup & connecting

2020-09-07 04:54:11 Servicial (0)
Enviar
respuestas (2)

Q: Did anyone measure the current draw in idle / load?

Preguntado por EtoOne sobre 2019-01-06 10:25:01

TiemeKuyper Idle load at 12V is 42mA

2020-09-07 04:52:05 Servicial (0)
Enviar
respuestas (2)

Q: does this have subwoofer output?

Preguntado por Samu245 sobre 2019-01-23 05:57:59

TiemeKuyper No, is has 2 stereo outputs which are already bridged, so not bridgeable for SW.

2020-09-07 04:49:46 Servicial (0)
Enviar
respuestas (2)

TiemeKuyper The output is connected to the input on this implementation causing terrible distortion. If you remove "CA" and "CB" (silk marking on the PCB) and connect the audio jack lines using a series 47kΩ and 4µ7 to the - inputs of the opamp (pins 2 & 6) then there is correct analog audio. I also increased the mute C (close to R21) to 33µF to reduce start pops and increased the input R's for the BT module (R1, R2, R5, R6) to 100k to reduce the hiss of the BT module. Working nice now.

2020-09-07 04:38:42 Servicial (0)
Enviar
respuestas (2)
TiemeKuyper 2020-05-26 07:06:32
0
Recomendaciones
Comentarios (0)

Los mejores críticos que te gusten: