Todos los mensajes

Q: Hi. Is this the one for the GEP RC Baby Crocodile 4"

Preguntado por Johnnysod sobre 2021-04-08 07:44:14

Phil Uhl Yes. But you can use any other whoopstyle board also

2021-04-16 06:38:49 Servicial (0)
Enviar
respuestas (1)

Q: Which target for flashing Betaflight?

Preguntado por CorpseGuard sobre 2020-12-14 11:14:36

Johnnysod As said before Matek405 However the other comment about voltage is incorrect The VTX supply voltage is 10v but the accepted voltage on the new design is Input voltage & power dissipation: 7V~24V, +12V 260mA@600mW So is fine. Just add an extra wire to get smart audio on port 3. The flight controller is the one listed for the Tyo129. Quite nice. Has lots of ports. Add GPS if you want. Buzzer connection and S6 for Cam control if you upgrade the camera to say Cadex Ratel

2020-12-15 03:37:41 Servicial (3)
Enviar
respuestas (5)

Q: how to be procedure to switch PAL / Ntsc ???

Preguntado por m.capasso.77@gmail.c sobre 2019-10-10 07:38:38

Johnnysod Betflight can't tell the camera to switch Pal or NTSC as it doesn't send it data. There must be a bridge to switch it but I don't know where. The next time I take the camera out I'll have a look...

2020-11-24 09:59:39 Servicial (0)
Enviar
respuestas (3)

Q: how to use Frsky xm+(SBUS)?

Preguntado por noobFPV sobre 2020-11-14 10:16:36

Johnnysod Solder the SBus pads and use UART 6

2020-11-24 06:10:20 Servicial (0)
Enviar
respuestas (2)

Johnnysod Not sure there is a futaba receiver, but you could fit a small one to the no receiver version. It's a fantastic drone, I use a T16i Radiomaster touch screen transmitter.

2020-10-29 12:14:39 Servicial (0)
Enviar
respuestas (1)

Q: the trasmitir have a bag?

Preguntado por miguelnavrib sobre 2020-03-24 02:26:37

Johnnysod It shows the Box in the last picture

2020-04-30 03:09:29 Servicial (0)
Enviar
respuestas (4)