Todos los mensajes

Diachoretic Yes DJI Air Unit is compatible. According to this drone: ID: 1581294

2020-07-05 10:26:03 Servicial (0)
Enviar
respuestas (1)

Q: is it compatible with HDV 220mm version of frame?

Preguntado por Nikita sobre 2020-06-14 03:53:35

Tushwas It can not compatible.

2020-07-05 04:36:12 Servicial (0)
Enviar
respuestas (1)

Q: is it fits vkar bison?

Preguntado por Nikita sobre 2018-01-07 05:39:32

JimmyLeo Yes

2020-06-11 07:10:12 Servicial (0)
Enviar
respuestas (1)

Nathan Long press two buttons on the vtx for about 5 seconds, set up your vtx table in betaflight, IRC Tramp vtx table. And set ypur vtx channel and power as well.

2020-06-09 06:23:48 Servicial (1)
Enviar
respuestas (1)

Q: can anyone please share stock pids?

Preguntado por Nikita sobre 2019-12-14 01:35:48

Matthew Taylor I don't think this is a Tuned Unit. It most likely is running on the stock Betaflight PIDs.

2020-02-28 11:24:12 Servicial (0)
Enviar
respuestas (2)

Nikita haha by default it connects by ppm to rxsr receiver (cppm out on board -> ppm / sbus in on receiver) so rxsr should be in ppm mode (press bind button for 4 seconds) and ppm to be configured in betaflight. and rx1 on board connecting to sbus out on receiver (why?). otherwise need to change wires 4 and 5 on connector so rx1 will connect to sbus in, but i just left it as is and use ppm.

2019-03-04 01:20:35 Servicial (0)
Enviar
respuestas (1)

Nikita haha by default it connects by ppm to rxsr receiver (cppm out on board -> ppm / sbus in on receiver) so rxsr should be in ppm mode (press bind button for 4 seconds) and ppm to be configured in betaflight. and rx1 on board connecting to sbus out on receiver (why?). otherwise need to change wires 4 and 5 on connector so rx1 will connect to sbus in, but i just left it as is and use ppm.

2019-03-04 01:20:35 Servicial (0)
Enviar
respuestas (1)