Mejores ofertas para Mobula7 HD,FPV Goggles - Banggood Spain Online Shopping

wacekdz

mis contenidos: Todos los mensajes; Comentarios; Comentarios; respuestas; Preguntas

Todos los mensajes

wacekdz 04/05/2019

It's a very nicely build copter. The motors have quite a lot of power and the Caddx Camera V2, though snugly fit, still does its job perfectly. It flies really well on 3S, which is great. It's still not perfect for freestyle, but the capabilities for the price are really great. There is a 'but' however. The ESCs are rated only for 5A on the Crazybee F4 V2.0 board, which the copter gets shipped with. Banggood started warning customers about lowering the throttle curve to ~75%, but that's just unjustified to sell the product knowing that it might burn out. Mine did. After falling into some debris, the motors spun just for a quick moment, enough to burn the F4 board (ESC + receiver chip - dunno why the latter?). It took along the Caddx Turtle V2 board as it's not powering up when supplying 5V externally (the FC is fried so had to reconnect it somewhere else). Overall BetaFPV at least tried to address the issue, here I don't think there's any support expected. Lowering the throttle curve is surely not the way to go, since any load on the motors will effectively burn the ESCs anyway. It's enough to hit a branch etc. Anyway the approximate repair cost is roughly 50% cost of the whole new copter. Not sue if it's worth at this point, as the ESCs may burn again. Too fragile in my opinion. Last flight of the Mobula 7 HD (its 5th in total): https://youtu.be/GfY7kNZyn1Q

Happymodel Mobula7 HD 2-3S 75mm Crazybee F4 Pro V3.0 Controlador de Vuelo AIO 10A ESC CineWhoop Drone de Carreras FPV PNP BNF con Motor 1102 9000KV y Cámara Runcam Splite3 Lite

US$177.09 US$184.99

4

Comentarios (0)

wacekdz 29/11/2018

The faceplate is definetely not made of leather - it's just some soft foam. Used it to exchange the original one in my FS Dominator V3s. It suits the goggles really well, You just have to cut it halfway, at the point where the nose goes, otherwise it won't reach the velcro on the goggle's faceplate. Once that's done, there's little to none light leakage and it's quite comfortable to wear. It's a bit thicker than the original fabric and it's rounded instead of being flat. Overall satisfied for the price.

2UDS Reemplazo de Almohadilla de Tela de Cuero de la Placa Frontal KIT Para Gafas FPV Fatshark

US$13.99 US$16.79

0

Comentarios (0)