Elemento de calentamiento de cerámica de repuesto A1321 de 24V 50W
Una parte de la reseña se ha traducido automáticamente.
This is not authentic Hakko A1321 only HAKO (one letter K). Resistances is good about 3.8Ω on red cables and about 39Ω on blue. Generally, I can recommend this element.
I am not specialist in heating elements, but as per explanations found in internet it is ceramic heater. It looks exactly as on pictures on this page. Has lable "hakko" on it. So I think it is a good buy. Was shipped fast well packad. Thanks Banggood.
heats fast. looks good , shipped fast . the wiring and soldering is well made . it also had the proper packet if you need . it was packed well. i will order more from here when i need.
I order this to replace my burn out element on my Yihua 907 solder pen. Very easy, just follow the manual provided. I. 1st desolder and take out the burnout element, 2. then put in the new A1321 element onto the pcb board, 3. bent the 4wires perfectly and solder it on, 4. then trim off the excess wires. 5. Used multi meter to check its resistance. 6. trimmed off a bit the white glass fabric tube as it's a little too long to blocking the solder housing to be screw back on. 7. screw back all holder and solder tip. Done. Here the slideshow. Pls like, thx. https://www.youtube.com/watch?v=xF-hDnmp93w&feature=youtu.be
heats fast, good quality, fastest shipping, good packet. had box and manual , and they were great if you need. came in mail home to me, i didn't need go post office. i recommend
Recibido en buen orden
El producto coincidía con la descripción.
Funciona bien. Estoy contento con eso.
Muy bien
Not tested yet. Well packaged.