Placa de Aluminio PCB con Cama Caliente 3MM MK3 para Impresora 3D Reprap Estándar
Una parte de la reseña se ha traducido automáticamente.
Unfortunately, not for further use. The fixing holes are completely destroyed. I hope Banggood will do something about it.
unfortunately the heating bed was pushed in at a corner. I think this is due to the poor packaging on the transport. How should we proceed now, because I could not so correctly installed. A shipping from Germany to Chine is also very expensive.
Like this way more than the thin PCB only, this wont warp like the PCB one does. Really Like it even tho it needs the smd resistor and led's .
Cheap and very well made.
Hallo, das heat Bed ist von guter Qualität und unterscheidet sich von in Deutschland gekauften nicht wirklich. Einzig und alleine macht der Preis den Unterschied. Man sollte jedoch bedenken das die Rückseite nur aus unbeschichteten Aluminium besteht. Also schwarz ist es nur auf der oberen Seite. Auch gibt es keine Anschlussflächen auf der Rückseite. Je nachdem was man für einen Drucker baut ist es eventuell nicht das richtige da z.B. der Mendel90 die Anschlüsse von unten hat.
Aún no lo he probado. Sin embargo, parece un producto de buena calidad. Tiene superficies muy lisas, y 3mm de grosor. Además, los envases no son muy buenos. Por lo tanto, las esquinas y los bordes del producto tienen algunos pequeños daños.
Nice but not yet tested
Good quality, and Flat. There is no SMD led, I don't know if i can work without, as I've the screen referencing all infos. Also, there is a little drop of welding tin on the boards, hope there is no short cut, I can't est it right now, waiting for other parts to make my 3D printer.
The product is of good quality, nicely packaged and does what it should do.
I was lucky, the bed arrived without damage although it wasn't very well packed. It's no MK3, the print is the same as my MK2b (red FR4). So you can mount at 3 or 4 points. There is a little hole in the middle too. That maybe a problem for printing directly on the surface. Flatness is ok but it's not 100% even, the edges are rised up a little, maybe 2 to 3/100 mm. All in all it's much better than the FR4 ones.