Reseñas de XGecu TL866II Plus Programador USB Soporte 15000 + IC SPI Flash NAND EEPROM MCU PIC AVR - Compras en línea de Banggood España

XGecu TL866II Plus Programador USB Soporte 15000 + IC SPI Flash NAND EEPROM MCU PIC AVR

US$75.06
~~US$77.99~~
Compra ahora

Comentarios de Clientes

4.89 fuera de 5

Ver todos 9 comentarios

5 estrella
8 (88.9%)
4 estrella
1 (11.1%)
3 estrella
0 (0%)
2 estrella
0 (0%)
1 estrella
0 (0%)

Escribe un Comentario Ganar dobles puntos de comentario si eres uno de los primeros 3 comentarios publicados.

Todos los comentarios (9)
Imagen (2)
Video (0)
Todas Las Estrellas
- Todas Las Estrellas(9)
- 5 Estrellas(8)
- 4 Estrellas(1)
- 3 Estrellas(0)
- 2 Estrellas(0)
- 1 Estrellas(0)

Ordenar por:

Comentarios Recomendados

Comentarios Recomendados
Muy útil
Más Reciente

Reseñas solo de tu país (Spain)

|

Mostrar original

Una parte de la reseña se ha traducido automáticamente.

LMPVIP4
PT
20/02/2020

DE ACUERDO

OK

DE ACUERDO
0

Comentarios

Mostrar original
GusVIP3
AR
05/04/2019

XGecu TL866II Plus USB Programmer. I followed the instructions runnning the setup file as administrator, updating the firmware and refreshing the system . I tested with a hct 32 logic : very nice ! ; then I inserted the chip atmega328P (with bootloader) a- Select the chip from menu Atmega 328P b- Read Id > c- Read (R) See the screenshot ... Proper price , working good . I ignore how it to could be recognized by MPlab x

XGecu TL866II Plus USB Programmer. I followed the instructions runnning the setup file as administrator, updating the firmware and refreshing the system . I tested with a hct 32 logic : very nice ! ; then I inserted the chip atmega328P (with bootloader) a- Select the chip from menu Atmega 328P b- Read Id > c- Read (R) See the screenshot ... Proper price , working good . I ignore how it to could be recognized by MPlab x

XGecu TL866II Plus USB Programmer. I followed the instructions runnning the setup file as administrator, updating the firmware and refreshing the system . I tested with a hct 32 logic : very nice ! ; then I inserted the chip atmega328P (with bootloader) a- Select the chip from menu Atmega 328P b- Read Id > c- Read (R) See the screenshot ... Proper price , working good . I ignore how it to could be recognized by MPlab x
0

Comentarios

Mostrar original

Show:

Total 0 paginas

Ir a la pagina

Vamos

recommendation for you