RS2VN
- mis contenidos
- Todos los mensajes
- Comentarios
- Comentarios
- respuestas
- Preguntas
respuestas
Q: what is the total width of the three cables toghether? thank you
Preguntado por niconico sobre 2021-09-25 02:14:38
RS2VN when 230 is visible means that you have chosen 230V input
Servicial (0)
Q: What wire gauge should I use for the battery connector and the ESC connector?
Preguntado por Christian Schneider sobre 2020-11-05 10:14:03
RS2VN Depends on the ESC and battery C. To be on the safe side use the same as it is on the ESC. If there is none, 14 AWG would be OK in most cases.
Servicial (0)
RS2VN basically UART 3 is vacant and should work. I suggest that you follow the schematics and connect crossfire to UART 6. Use UART 3 for VTX (smart audio or IRC Trump).
Servicial (0)
Q: can i know how to wire it? i burned already an FC.
Preguntado por Gianluca Puntara sobre 2019-03-03 05:31:00
RS2VN GNDto GND (FC), 5V to 5V (FC), PB- to B- (FC), Din to LED (FC)
Servicial (0)Q: am I correct in saying this firmware is FuryF4OSD (Diat)?
Preguntado por mariomazzanti23 sobre 2020-02-06 05:57:09
RS2VN Yes.But I have switched back to legacy (3.5) since 4.1 behaved creasy.
Servicial (0)
RS2VN cca 3.7 mm
Servicial (0)