BG332373951
- mis contenidos
- Todos los mensajes
- Comentarios
- Comentarios
- respuestas
- Preguntas
respuestas
Q: Hello, Is this cable create a paralell connection between the motors, or serial?
Preguntado por tsoft sobre 2022-06-14 01:24:59
BG332373951 Itis parallel connection for 2 steppers to one board port.
Servicial (0)
Q: Any chance these work on Anycubic Mega Pro!?
Preguntado por MarckOliver sobre 2022-10-18 03:41:26
BG332373951 I think not. One of silicon column is sorter than other 3.
Servicial (0)
Q: Can I run several LED strips off one WeMos board?
Preguntado por BG218056221 sobre 2022-03-30 16:26:49
BG332373951 Yes you can if use external power supply for led strips. 5V pin of D1 mini is not capable to supply a led strip.
Servicial (0)
Q: Will this work with Alfawise U20 one?
Preguntado por Audenhuff sobre 2021-01-17 01:05:26
BG332373951 Probablybut you have to check your board connections and your firmware. Will not work without proper firmware.
Servicial (0)
Q: Would this product be compatible with the geeetech a20m?
Preguntado por BG411723169 sobre 2021-11-15 23:09:54
BG332373951 Seemsto be compatible. Same extruder kit, but you need to check your steps of extruder in firmware.
Servicial (0)
BG332373951 Yesit is compatible. Yes it needs firmware that will support BLTOUCH. No it is not plug and play. You need to look at github of BIGTREE. It has pictures for connections. You don't need ISP programmer and little board.
Servicial (0)
BG332373951 No you can not! For up to 3A you must use a LM2596 for step down (with heat sink) or XL5009 for step up (with heat sink)
Servicial (0)
BG332373951 If X axis is 2020 extrusion probably does. Be aware of timing belt length. Also you should look out of hot end compatibility
Servicial (1)