Todos los mensajes

kotopuz 17/10/2019
Good device. Tried that on home appliances with AC motors and all can be regulated well. It has no speed control and on low RPM you not getting enough torque, but for money you pay it's great thing to work with. Tried on hand drill and washing machine motor, both work ok. I can hear some harmonics on low RPM which means that output is not a filtered clear sign ware, but device does it's job. Design of terminals is very clever as screw 2 and 3 are both phase wires. It means chance to have short circuit between two screws (water, metal chips, loosen wire or its parts, dust) is much lower. It's small thing which could be important for long term use. As you can see from picture there is no dedicated ground connection. Temporary I've connected it to available screw on the left of 4 screws used for power in and out. Do not thing that you will be lucky and without ground and some DIY equipment without double insulation. Make a ground connection and use RCB breaker feed power connection, otherwise you may get killed in case of internal electronics failure or dust or water causing phase to tough casing -> then you. RCB will power off in such situation and in most cases you will get only 30ma (industrial set to 200ma). Make sure to use device one you know about safety, double insulation of toolds and appliances, what is RCB breaker, what is Phase and what is Neutral (in US there are two phase wires). Overall I recommend this device as it sustained ~400-500 watt load for 5 minutes without smoke or burning and appear to robust.
7
Recomendaciones
Comentarios (0)

BG478129173 You can easily grind your own costume cutter for parting. This has always seemed to work better for me by reducing the vibration. Of course this will be limited to depth but mini lathes can't handle a deep cut well anyways.

2021-02-06 12:44:53 Servicial (0)
Enviar
respuestas (2)

Q: does it have a comparoble tool holder for 20mm high blade or bigger?

Preguntado por kotopuz sobre 2019-08-05 03:58:19

idoc59 1x3/8" porte ennuyeux 1x 1/2" cut-off capacit support lame 2x 1 / 4-3 / 8" tournant et face supports 2x boulons de fixation (M8 et M10)

2019-11-07 09:57:41 Servicial (0)
Enviar
respuestas (2)

Dure The G code is set as ISO90 standard. Only some instruction is specific, but it is not conflict. It needs pay attention to the format of G code. And here's the manual: http://img.banggood.com/file/products/20190213012914SMC5-5.pdf

2019-11-01 05:04:23 Servicial (0)
Enviar
respuestas (1)

linyijia Recommand: holder : ID 1526877 1193185 1324524 1562801 1020041 1133192 motors:1382630 1226791 1229659 1252939 1338991

2019-10-10 04:37:57 Servicial (0)
Enviar
respuestas (1)

AbsurSpew Motor speed can be set via control application software and driver board

2019-09-20 09:27:43 Servicial (1)
Enviar
respuestas (1)