brandonhill
mis contenidos
Todos los mensajes
Comentarios
Comentarios
respuestas
Preguntas

Todos los mensajes

brandonhill 04/02/2019
Great board. Replaced a Ramps v1.4 board with blown Vreg. Board mount plus heatsink are great upgrades, plus better terminals. Has blue ext./bed LEDs instead of red, too (ooh!). A couple pins were bent on arrival, but easy enough to fix. One row of pins was soldered on a slight angle, but also easy to straighten. Overall an easy upgrade/replacement and great value.
Actualización Ramps 1.6 Basado en Ramps 1.5 Panel de Control Placa Principal Tablero de Expansión para Piezas de Impresora 3D
US$16.16 US$16.99
1
Recomendaciones
Comentarios (0)
EWRF e7082C 25mW/100mW/200mW/OFF Potencia Ajustable 5.8G 48CH AIO VTX FPV Transmisor
US$24.24 US$25.19

Q: is the OSD wire (green) the same as video out? or go to the video out pad on the FC?

Preguntado por earthquake_indu sobre 2019-03-11 07:14:11

brandonhill No, it's the signal for TBS SmartAudio control via Betaflight OSD.

2020-05-10 09:10:47 Servicial (0)
Enviar
respuestas (1)
brandonhill 04/02/2019
Great stepper drivers. Description and pictures don't show it, but they come with step stick protectors, which is nice. They're suitable for drop-in replacements (in Marlin, you need to change drivers to TMC_STANDALONE), but not for their full capabilities (comm. with Ramps board) since pins are pre-soldered. Good value. Awesome drivers. So smooth.
5Pcs/Pack
US$65.82 US$68.99
0
Recomendaciones
Comentarios (0)
brandonhill 15/02/2019
I only received 9, but still, they're good little connectors. I'm replacing lots of my JST connectors with these because they're better and best of all, reusable. Pretty sure these are a different make than the XT60s sold here, and seem of better quality.
Conector de interfaz macho hembra dorado XT30 de 10 pares de 2 mm
US$13.85 US$14.99
0
Recomendaciones
Comentarios (0)
brandonhill 15/02/2019
Highly recommend these props! Replaced some King Kong 2840x3 and my throttle at hover decreased about 5%. Beware that screws are not included and the hub is shorter than most three hole props. I used 6mm screws rather than the typical 8mm, and there's just enough thread exposed. If you use 8mm screws make sure your motor can accommodate the extra length (and the screws don't hit the windings). Will definitely be using these on any 3" build.
6 Pares Hélice CW CCW de RC Drone FPV Racing ​de 3 Palas Emax AVAN Mini 3 Pulgadas 3X2.4X3
US$8.04 US$13.99
0
Recomendaciones
Comentarios (0)
brandonhill 10/02/2019
Noticeably better than a dipole antenna. Super small and light. Good quality. A bit pricy, but the easily best choice for micro FPV right now.
Realacc UXII Stubby RHCP U.FL/IPEX IPX 5.8GHz 1.6dBi Antena Súper Mini Para Gafas de Protección TX RX Fatshark RC Drone
US$12.09 US$13.19
0
Recomendaciones
Comentarios (0)
3.3mm 780nm 200mW Infrarrojo IR Láser Diodo Láser Generador de Módulo
US$9.23 US$9.99

Q: is it visible

Preguntado por karvariyaj sobre 2018-06-02 01:49:11

brandonhill No. Visible spectrum ends around 700nm.

2019-01-30 07:45:01 Servicial (0)
Enviar
respuestas (1)
brandonhill 21/12/2018
Looks of average build quality. Performs fine. PCB edge covers are silicone instead of heatshrink, and don't stay in place at all.
Pagoda LHCP/RHCP 60mm 5.8G 2dBi FPV Antena SMA/RP-SMA Con Caja Rojo/Púrpura
US$4.63
0
Recomendaciones
Comentarios (0)
brandonhill 18/12/2018
Both connectors look good. Heat shrink is well placed.
Cable de conexión DANIU 10cm PCI U.FL / IPX a hembra RP-SMA
US$8.07 US$15.99
0
Recomendaciones
Comentarios (0)

Usted es el experto, ¿puede ayudarme?

¡Te invitamos sinceramente a suscribirte al correo electrónico de respuesta de invitación!

Si se suscribe, lo invitaremos por correo electrónico para que responda las preguntas que la gente tenga sobre los productos. ¡Al suscribirte, también ganarás la "Insignia útil "! Puede darse de baja en cualquier momento en la página de configuración de privacidad.

¡Ayuda a los demás y sé más feliz!

  • Suscribir

Sobre insignias

Las insignias están relacionadas con la comunidad, y los usuarios obtienen insignias creando contenido de calidad, completando misiones o participando en actividades especiales. Las personas específicas también tendrán su propia insignia exclusiva.
Insignia del CEO

La insignia del CEO es propiedad exclusiva del jefe de Banggood.

Las insignias que puedes ganar llegarán pronto
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe