Mejores ofertas para Control de vuelo,Tubo de alimentación

Cliffyd33 10/09/2020

really good brushed board. Amazon is asking like over $90 for this same one. i use these all the time!

Placa de control de vuelo Eachine Beecore F3_EVO_Brushed para Inductrix Tiny Whoop Eachine E010 E010S

30,89€ 32,28€

0

Comentarios (0)

Tubo de alimentación de tubo de teflón para impresora 3D - 3,00 mm 4 × 6 mm - RepRap

8,52€ 9,22€

Q: will this work for 2.8mm filliament?

Preguntado por Cliffyd33 sobre 2020-05-03 07:08:21

WayJJJJ no, it is for 1.75mm filament

2020-05-28 01:26:31 Servicial

Enviar

respuestas (1)

Cliffyd33 19/05/2019

Small, Campact and easy to use. Perfect for miceo Qwad builds and binds to my dx6e no problem!

MOY DS801 DSMX DSM2 Mini Compatible Receptor con salida SBUS PPM

9,59€ 10,44€

1

Comentarios (0)

Cliffyd33 justset it for ppm (let it blink for 30 secs) provider is easy, just ppm as provider and done. I had same issues.

tglynn 28/08/2017

Using this on a new Emax Babyhawk. Can't get it to bind as DSMX, my DX-8 only binds it as DSM2/22ms (1024) but this could be the DX-8, it is running 3.01 software. One tip is I had to hold the DX-8 about 2 metres away during binding. The MOY runs on 3.3 to 5.5V so connection is simple. In Betaflight you need to set it up as Spektrum 1024 and SBUS as the provider. Another tip is sometimes Betaflight doesn't seem to show the device connected in the receiver dialog. It shows the channels but not the bars. Trick here is to ensure that the Low/Mid/High values aren't zero, Set them to something like 1200/1500/1800 and the "bars" then appear. Range is good. I was flying ~50m away on FPV. Seems like good value.

MOY DS801 DSMX DSM2 Mini Compatible Receptor con salida SBUS PPM

9,59€ 10,44€

2

Comentarios (2)

Cliffyd33 isthat an acrylic frame?

fpvant 23/04/2019

okokok not to bad

Actualización de 20x20 mm Betaflight F4 Noxe V1 Controlador de vuelo AIO OSD 5V 8V BEC con barómetro y caja negra para RC Drone FPV Racing

21,21€ 25,82€

2

Comentarios (1)

Cliffyd33 02/10/2019

very good for the price. would buy more and perfect for brushed builds

Eachine TX06 700TVL FOV 120 grados 5,8Ghz 48CH 25mW Cámara Mini FPV con soporte de audio inteligente Pitmode AIO Transmisor para RC Drone Tiny Whoop

27,67€ 52,02€

0

Comentarios (0)

Cliffyd33 02/10/2019

must have kit for any diy drone enthusiest

Suleve™ M3NH5 180 piezas M3 Nylon Tornillo Hex negro Tornillo Tuerca PCB Separador Columna Kit surtido

14,91€ 15,67€

0

Comentarios (0)

Cliffyd33 02/10/2019

Atleast these ones are a bit better glued

Pieza de Repuesto URUAV UR65 FPV Racing Drone Motor Sin Escobillas SE0603 17000KV 1S

9,30€ 11,16€

0

Comentarios (0)

Cliffyd33 22/08/2019

This drone is the hottest item on youtube for inexpensive micro fpv racers. cant beat the price for a complete quad. I love mine you just need a reciever and battery obviously. A++++

Eachine Tyro79 140 mm 3 Inch DIY Versión FPV Racing RC Drone F4 OSD 20A BLHeli_S 40CH 200mW 700TVL FPV Camera

120,94€ 126,38€

0

Comentarios (0)

Cliffyd33 22/08/2019

This is my 2nd one of these rx's I bought, theyre so friggin tiny, they are perfect for the smallest pepperfish or and ultra micro build. Highly recommend this reciever!

Pequeña 2.4G 6ch receptor compatible con dsm2 ppm señal de salida para Eachine qx80 qx90 qx95

22,36€ 23,98€

0

Comentarios (0)

Cliffyd33 12/08/2019

Very small motors. these are for my ultra micro 1s builds, like the pepperrfish. Its nice because all my brushed coreless motorslike inductrix, the props fit so i have lots of props that fit.

Pieza de Repuesto URUAV UR65 FPV Racing Drone Motor Sin Escobillas SE0603 17000KV 1S

9,30€ 11,16€

0

Comentarios (0)

Cliffyd33 20/06/2019

nice carbon frame for micro builds. I plan to buy canopy for this as well

Kit de marco de cuadricóptero de micro FPV RC DIY de 100MM compatible con motor sin núcleo de 8520

14,91€ 15,67€

0

Comentarios (0)

Cliffyd33 20/06/2019

tiny and perfect for my micro brushed builds. I plan to buy a few of these.

Transmisor FPV Eachine VTX01 Super Mini 5.8G 40CH 25mW para drones RC

23,05€ 52,39€

0

Comentarios (0)

Cliffyd33 12/07/2018

So easy to use with my radiolink AT9. Plugged it in to my F3 evo with 3 wires and turned on my radio and bound! done!

Receptor Radiolink R6DSM 2.4G 10CH DSSS FHSS para AT9 AT9S AT10 AT10Ⅱ Salida PPM SBUS

21,30€ 22,13€

0

Comentarios (0)

Cliffyd33 04/07/2018

long time to get here but it was my post office's fault so no issue with banggood. A+ as usual

2X Eachine Hélice de 3 Hojas 8Unids y 8,5x20mm Motor sin Núcleo 4Unids para DIY Marco del Cuadricóptero FPV Micro

10,14€

0

Comentarios (0)

Cliffyd33 17/06/2018

Bangood sent me this replacment board for me right away without any hassles!

32bits micro f3 cepillado placa de control de vuelo basado en las carreras sp F3 EVO cepillo para qx 95 qx 90 qx80

10,14€

0

Comentarios (0)

Cliffyd33 03/05/2018

I love this little camera, most everyone uses this for micro quad builds.

600TVL 1/4 1.8mm CMOS FPV 170 Grados de Amplia Angular Cámara de Lente PAL/NTSC 3.7-5V

11,15€ 17,70€

0

Comentarios (0)

Cliffyd33 16/04/2018

Got this for my step daughter with a bunch other make up. she really likes it and was quite excited to use it so I guess its pretty nice.

Juego de paleta de sombras de ojos mini de 40 colores Banggood Brilho Shimmer Cosmetic Portable Eye Maquillaje

24,35€ 26,75€

0

Comentarios (0)

Cliffyd33 16/04/2018

I use it on my micro drone to feed my txo3 mini fpv cam 5v and seems to clear up motor noise as well for a clear video signal. I think if your gonna fly micro you need one of these

Módulo de alimentación de impulso de voltaje ascendente de CC a CC 3.7V a 5V para quadcóptero de carreras con motor eléctrico

4,83€ 8,29€

0

Comentarios (0)

Bienvenido a Banggood,

Usted permite:

Todos los mensajes

Usted es el experto, ¿puede ayudarme?

Sobre insignias

About Badges

Helpful Badges

Are you ready to help?