Todos los mensajes

Q: Can you turn off sleep mode for on all the time display?

Preguntado por PlaneKrazytoo sobre 2018-03-29 06:10:16

Joker666 Yes , you can use only "the Red Headlight" .

2021-10-10 05:05:44 Servicial (0)
Enviar
respuestas (1)

Q: which led program box works with this?

Preguntado por PlaneKrazytoo sobre 2020-09-28 04:17:15

BG441042941 I’ve been using the standard hobbywing program card and it’s worked on every hobbywing esc I’ve got. Up to 150 amp. Several SC8 and MAX8. If you’re wondering which one to order with it. I’d order the slightly more expensive LCD hobbywing programmer just to be safe. That one covers most everything they make

2021-07-19 02:37:45 Servicial (1)
Enviar
respuestas (3)

PlaneKrazytoo yes it is compatible with the frsky x9d Plus. and it does drop in and runs with the selector switch in back for all the common formats using PMP which is the slower versus serial. it is a bit of a headache 2 buy the pieces to install the bootloader to upgrade. are there is two other methods that all are conditional and complex. I am not happy that it is sold without the bootloader installed which would only take them minutes and put it on the consumer.

2020-10-30 05:12:59 Servicial (0)
Enviar
respuestas (8)

PlaneKrazytoo these are three-phase AC. Eustace plaid DC do the ESC which is the speed controller it puts it out in a 3-phase Square wave 1 wave down each of the three wires out of phase of each other. and the difference in phase causes the flow of electricity across the three poles that can be multiplied around the axis of rotation. so the motor can be three pole 6 Pole 9 Pole 12 Pole or any multiple of 3. you must Supply DC to the ESC. the ACU Supply from the wall is a single phase and must be processed into a three phase. without very special Electronics the common way is 2 converted to DC provided to the ESC that converts it back to 3 AC square waves to feed through the wires to the motor. no you cannot connect this directly to the wall plug. now if you really want to get confused you can't get an AC pure motor and buy one of these and spin it with the AC motor rotation and energy will come out the wires that you can feed into another one and it will rotate NSYNC. so if you mechanically drive this you actually get to three phase out the back side. and can feed it right into another one. there is power losses for this system but it does work.

2020-09-28 03:54:08 Servicial (3)
Enviar
respuestas (16)

Q: can it run on a 9v battery?

Preguntado por mattves14 sobre 2019-11-13 09:41:32

PlaneKrazytoo yes 9 volt battery will run it. but it will not shut off and we'll run the battery to zero. but at a third of an amp you should have at least half a day on a 9 volt battery.

2020-09-12 11:59:12 Servicial (0)
Enviar
respuestas (4)

Q: What is usb cable for?

Preguntado por sh5 sobre 2018-03-19 12:34:01

PlaneKrazytoo The USB is for the 5V power to the LED display. You provide the USB power source.

2018-03-27 03:01:58 Servicial (0)
Enviar
respuestas (2)