Darren
mis contenidos
Todos los mensajes
Comentarios
Comentarios
respuestas
Preguntas

Todos los mensajes

Darren 30/10/2018
Mine arrived in very poor condition, both lenses were floating and not secured properly. The 2x 18650's used in mine were generic Chinese cells and had a real capacity of 2000mAh not 2200mAh. On the stock generic cells the runtime on full was respectable at a few hours. I modded mine and upgraded to 2x Sanyo NCR18650GA's which had a very noticeable effect on the runtime. Don't try to do this unless you are comfortable with soldering as it's not a simple or particularly easy job, you will need to spot weld your new cells together and swap over the battery protection and then squeeze everything back into the aluminium body. I did not notice much if any increase in output from changing the wires to a larger AWG or the lower resistance cells, I would assume this is because the stock wires are sufficient and the light is regulated. I did not do any current measurements but going by the output in comparison to another genuine Cree torch I would say it is around 1000 lumens MAX. The heat sinking to the main aluminium body is near enough non existent but the small contact area it does have did not have any thermal compound, I am extremely surprised it runs as well as it does. Overall it's a nice looking light that works well but the actual spec is WAY off, my estimate would be 1000 lumen 5500K 75CRI with a 4000mAh battery which in comparison to the leading brands of bike lights makes this still well worth the money!
XANES DL07 1800LM 2 * L2 4400mAh Recargable Batería Luz indicadora de bicicleta
US$36.95 US$38.99
4
Recomendaciones
Comentarios (1)
Darren 01/12/2018
Nice quality straps!
Correa de sujeción Magic Tape de RJX HOBBY para batería de RC
US$8.07 US$8.99
0
Recomendaciones
Comentarios (0)
Darren 01/12/2018
Seem decent for the money, they also use silicone wire which is much better than the cheaper ones I have seen.
Batería de Li-Po Cable de Alambre de Extensión de Carga del Equilibrio 20cm 2S 3S 4S 6S
US$5.74 US$5.99
0
Recomendaciones
Comentarios (0)
Darren 01/12/2018
I wish they did larger packs of this, it's good stuff!
127Unids 2:1 Tubo Termorretráctil Libre de Halógeno Cable de Alambre de Envoltura Tubería Kit
US$9.23 US$12.99
0
Recomendaciones
Comentarios (0)
Darren 01/12/2018
The heat resistance of this tape is great.
Cinta Resistente al Calor de Película de Poliamida de Alta Temperatura de 5 Tamaños
US$4.61 US$4.99
0
Recomendaciones
Comentarios (0)
Darren 01/12/2018
Good for the money!
Cable de Equilibrio de LiPo JST-XH 2S 3S 4S 5S 6S para Carga de Alimentación de 10CM
US$11.54 US$11.99
0
Recomendaciones
Comentarios (0)
Darren 01/12/2018
I have purchased a few of these now and can honestly say they are quite good. Well done Banggood!
Placa de protección de batería de litio Li-ion 18650 14S 45A 52V Módulo de equilibrio de celdas
US$26.55 US$27.99
0
Recomendaciones
Comentarios (0)
Darren 01/12/2018
I had lots of problems with this, it seems much more inaccurate than a regular ruler and the solar part of it is useless under led light (which is not a surprise).
150mm lcd herramienta calibrador digital de medición compuesto de fibra de carbono solar
US$19.62 US$20.99
0
Recomendaciones
Comentarios (1)
TRONXY® X5ST-400 DIY Kit de impresora 3D de aluminio 400 * 400 * 400 mm Tamaño de impresión grande
US$389.99 US$505.99

Q: I have the Tronxy XY-08N level sensor for the X5ST, how do I enable it?

Preguntado por Darren sobre 2018-11-30 01:23:18

Waddleeeenn if it is plug and play type, can use directly

2018-12-04 09:34:44 Servicial (0)
Enviar
respuestas (1)
Darren 28/11/2018
This printer is awful. It came with absolutely no instructions what so ever and the bed is totally warped which makes it useless. If you use glass over the top you will have uneven heating and possibly bend or break the glass. The extruder motor is also faulty. The printer was also supplied with some 3d printed parts which I would not expect from a printer kit of this value. The only good thing about is all the revised parts from all of the other versions of it like the X5S etc.
TRONXY® X5ST-400 DIY Kit de impresora 3D de aluminio 400 * 400 * 400 mm Tamaño de impresión grande
US$389.99 US$505.99
3
Recomendaciones
Comentarios (1)
TRONXY® X5ST-400 DIY Kit de impresora 3D de aluminio 400 * 400 * 400 mm Tamaño de impresión grande
US$389.99 US$505.99

Q: I have the sensor to upgrade my X5ST 400 but how do I turn on the firmware support?

Preguntado por Darren sobre 2018-11-23 12:21:51

Lovable what sensor

2018-11-27 03:13:58 Servicial (0)
Enviar
respuestas (1)
Darren 30/10/2018
Good stuff. I have not tested it's resistance to heat or flames but it seems just like all the other insulation tapes I have used. It also has a nice pattern embossed into it which makes it look a bit more expensive than regular insulation tapes (which it is).
Cinta Aislante Eléctrica de ​10M Cinta Adhesiva Eléctrica para Hogar
US$2.99 US$4.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
This alarm is quite good quality and functions well. The range of the remote is very good, the LED is quite bright and the battery life is good.
ANTUSI 3 en 1 Luz trasera inalámbrica para bicicleta Control remoto de ciclismo Alarma de bloqueo de bicicleta de montaña
US$28.86 US$38.00
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
I have purchased quite a few of these and they have always been of reasonable quality. The price has increased over the last few months though.
Soporte de batería DIY de 4 ranuras para 10pcs 18650 con 8 cables
US$22.99 US$26.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
These will not accept a heavy AWG wire. They perform OK and are pretty sturdy but if you want to use them at high current due to their "copper" material then you should probably look for something else as they simply will not accept more than 12AWG.
DANIU P3008 10Unids 4mm Enchufe de Plátano de Cobre
US$13.85 US$14.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
Very nice fitting covers!
Cubierta protectora de plástico para enchufe XT60 de 3 piezas para dron de carreras RC multirotor FPV Spark
US$6.29 US$8.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
Very nice stuff, it's reasonably priced and performs very well under extremely high temperatures.
Cinta Resistente al Calor de Película de Poliamida de Alta Temperatura de 5 Tamaños
US$4.61 US$4.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
The quality of these vary massively. I have had 2 batches of these and there is a huge difference in quality. The first batch was really good quality and fitted very nicely but the second batch was really bad. It's the chance you take I guess when buying from China.
20 Pares de Conectores Banana Amass de 4.0mm AM-1003E Macho y Hembra
US$28.86 US$29.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
This stuff is quite good, I have not done any resistance tests but there is a noticeable quality difference when comparing this against another 8AWG silicone wire. I can't totally recommend this wire without doing a resistance test but I will say that going by the quality it will most likely be good stuff.
1M 8/10/12/14/16/18/20/22/24/26 AWG Cable de silicona SR Wire
US$4.95 US$6.99
0
Recomendaciones
Comentarios (0)
Darren 30/10/2018
These are a very very tight fit, I had to warm mine up to make them fit but after that they fitted perfectly.
Cubierta protectora AMASS XT60 XT90-S Anti-chispa de TPU para impresión 3D para cableado de modelos RC (2 unidades)
US$6.92 US$7.99
0
Recomendaciones
Comentarios (0)

Usted es el experto, ¿puede ayudarme?

¡Te invitamos sinceramente a suscribirte al correo electrónico de respuesta de invitación!

Si se suscribe, lo invitaremos por correo electrónico para que responda las preguntas que la gente tenga sobre los productos. ¡Al suscribirte, también ganarás la "Insignia útil "! Puede darse de baja en cualquier momento en la página de configuración de privacidad.

¡Ayuda a los demás y sé más feliz!

  • Suscribir

Sobre insignias

Las insignias están relacionadas con la comunidad, y los usuarios obtienen insignias creando contenido de calidad, completando misiones o participando en actividades especiales. Las personas específicas también tendrán su propia insignia exclusiva.
Insignia del CEO

La insignia del CEO es propiedad exclusiva del jefe de Banggood.

Las insignias que puedes ganar llegarán pronto
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe