BG126124112 Are your Elevators Reversed? Stick Back Elevator goes UP !!! Hold the elevator up to keep nose down let it roll forwards till you get lift then ease forwards on stick Then Stick back to climb.Or repo... Are your Elevators Reversed? Stick Back Elevator goes UP !!! Hold the elevator up to keep nose down let it roll forwards till you get lift then ease forwards on stick Then Stick back to climb.Or reposition the control rod in a hole Nearer to the Elevator to give it more throw as it might need to overcome the downward thrust of the engine when power is applied.Try without flaps at first. Ver Más

FlyingSandal i fly mine with 5000 mAh 4S battery, lined up with the front of the battery tray and it balances well

Maccarocks Usinga 1060 prop the 850kv will easily pull models up to 1000gms then it starts to struggle a bit but can still work... but with the same prop using the 1050kv it will pull models up to 1400gms easil... Usinga 1060 prop the 850kv will easily pull models up to 1000gms then it starts to struggle a bit but can still work... but with the same prop using the 1050kv it will pull models up to 1400gms easily... best motor ..!! Ver Más

mihaiscot Wedont know.... maybe Koronavirus?! ...... :)

Vivi kv1050

rocketmrv Not sure of power difference,depends on propeller. Volts X Kv = RPM. 10 volts X 850 = 8,500 rpm. 10 volts x 1050= 10,500 rpm. Therefore,the 850Kv motor will spin a bigger prop than the 1050Kv. A wattm... Not sure of power difference,depends on propeller. Volts X Kv = RPM. 10 volts X 850 = 8,500 rpm. 10 volts x 1050= 10,500 rpm. Therefore,the 850Kv motor will spin a bigger prop than the 1050Kv. A wattmeter will be useful to help pick prop size and give you a (static) reading of power. Overloading of motor can occur if too big a prop is used. Also,static reading of wattmeter should be slightly higher than actual reading during flight. (loaded when not moving.) Wattmeters are an indispensable tool for working out power,prop size etc. and are fairly inexpensive. (mine cost @$15.) Hope this helps you. Ver Más

Super_Sweet yes it included motor.

bobpen1970 D4 * is axle diameter , L43* is total length, 32 mm is axle length, M4 is hole size for landing gear !