Todos los mensajes

GreenscOOps the standard firmware only allow you to use 6 channels. you need to buy the firmware update cable and download the custom firmware from github.

2022-07-25 07:39:07 Servicial (0)
Enviar
respuestas (6)

pfeerick I've not used the Flysky i6 transmitter personally, but it is telemetry capably, and has the sensors list and choose sensors options under "system - rx setup". However I do have both this receiver and the smaller 6CH version, and to use sensors to monitor things like flight battery, altitude, RPM you use the SENS iBus port. And for basic RSSI, receiver voltage, etc, you don't need to connect anything, that is sent anyway.

2022-07-16 11:23:22 Servicial (0)
Enviar
respuestas (1)

Q: what do you use for a video receiver? I've never seen goggles that aren't 5.8GHz

Preguntado por GreenscOOps sobre 2022-04-01 08:13:55

qurlson Matek have receiver, or another china receivers and use 5.8 vtx for repeat signal in goggle

2022-06-04 12:19:26 Servicial (1)
Enviar
respuestas (1)

Q: does it work if i mount this under my carbon top plate of my quad?

Preguntado por Nicoman10 sobre 2019-07-01 11:36:47

GreenscOOps No

2022-04-03 06:36:06 Servicial (0)
Enviar
respuestas (6)

Q: can this gps be configured to show the drone distance in the goggles' OSD?

Preguntado por BG947171221 sobre 2021-05-29 03:03:59

GreenscOOps there is no configuring the gps but yes on screen display can be setup to show distance to the home point which only works if you have a gps on your craft.

2022-03-22 02:08:37 Servicial (0)
Enviar
respuestas (2)

Q: Can i Connect the receiver with 7,4volt 800mah lipo and bec?

Preguntado por alextattoo sobre 2020-01-06 11:42:08

GreenscOOps as long as the BEC outputs 5v. You don't want to plug a 2s lipo directly into the receiver.

2022-03-22 02:05:31 Servicial (0)
Enviar
respuestas (2)

Q: Does this works with the FC Racestar Star F4s 30a

Preguntado por armandomonroyph sobre 2019-10-29 06:40:19

GreenscOOps it will work with any flight controller that's has a spare UART.

2022-03-22 01:43:25 Servicial (0)
Enviar
respuestas (2)

Q: does this ESC work with any brushless motor

Preguntado por Utsav Atul sobre 2018-02-07 08:01:42

GreenscOOps any brushless motor that has a maximum current draw of less than 30 amps

2022-03-09 03:51:25 Servicial (0)
Enviar
respuestas (2)

Q: Which side on top of this GPS unit, please? Thanks in advance!

Preguntado por SilverSurfer sobre 2018-06-29 09:22:49

GreenscOOps antenna side up. the side with the little dot in the middle.

2022-03-09 03:49:41 Servicial (0)
Enviar
respuestas (3)

GreenscOOps it can't run off of USB power you need to plug in the battery also

2022-03-02 06:08:35 Servicial (0)
Enviar
respuestas (6)

Q: how much Ampere esc cao use

Preguntado por BG571710105 sobre 2022-02-15 11:16:02

GreenscOOps well it says the max current the motor will pull is 11.5 amps so you'll need a ESC that can handle at least 12 amps but a little higher might be better just in case so a 12-20 Amp ESC will do. I use a 30A ESC because it was what I could find cheap.

2022-02-16 06:18:03 Servicial (1)
Enviar
respuestas (2)